DrJarmin
Standards Associate
Sorry, More than likely this should be apparent, but i cannot figure it out – despite if looking through the handbook!
How do I link our Yamaha RX3900 recipient to a Velodyne CHT-Q series subwoofer.
The subwoofer enjoys stereo (l+r) stimulant (all You will find held prior to now experienced mono stimulant) and so the yamaha amplifier doesn’t have a sub production just where all the other speaker system outputs are located.
Gratitude, and satisfy disregard our stupidity – Most probably the clear answer can be obvious once i understand.
IronGiant
Moderator
You intend to hook the Pre-OUT sub the Yamaha to either the put or suitable station to the Velodyne
It is simply above the heart for the three orange electronic coaxial inputs to the Yamaha
Change: apologies that one’s a feedback, the one you need try a couple more to the correct just like you effectively recognized they.
DrJarmin
Requirements Manhood
All right, thanks a lot. It was the left and right that has been puzzling myself.
How come the sub have gone and best channels?
IronGiant
Moderator
When your amp doesn’t have a dedicated submarine woofer route ie is definitely HiFi certainly not an AV receiver, but provides stereo pre-outs, possible send out the full assortment right and left network toward the sub the submarine to remove the LFE wavelengths from.
As you have the LFE as a mono sign you won’t need to connect to both, though some consumers accomplish using a phono splitter. Numerous subs have one or some other of this right and left likewise denoted all the way up as mono, or perhaps you can find your sub guide advocate one during the some other.
DrJarmin
Standards User
Ah, ok, In my opinion I have it.
There can be a lot to understand with this field.
Thank you for your own services.
DrJarmin
Standards Associate
One finally doubt, appears to be We would like a line with a male connector at one extreme (to connect the Yamaha) and a simple wire on the other side (for connecting to either the put or appropriate input on backside regarding the sub).
I’ve a good number of AV leads with connectors on, do I just reduce one finish away and rehearse that? They are not particularly hefty assess cable, precisely the sort of line you could get in a Maplins or Dixons. Will that become sufficient?
DrJarmin
Expectations User
I have attemptedto hook up the sub – but it isn’t doing work. Exactly what was I creating completely wrong?
I got myself an RCA wire and cut off one stop. Undecided if I 
should take advantage of middle line, and/or outside line for remaining or ideal, but attempted both.
The sub only has actually a steady hum.
Another end is definitely connected to the back of the RX3900 for the submarine woofer connector, certainly not the main one higher than the 3 orange fittings, but further along off to the right in identical strip (witness connected).
Accessories
paulst10
Recognized Member
I got myself an RCA cable tv and block one end. Uncertain if I should operate the center wire, your external wire for left or right, but tried using both.
The subwoofer just has a consistent hum.
Other stop was attached to the back of the RX3900 inside the sub woofer connector, maybe not the main higher than the 3 tangerine fittings, but farther along along right in the same strip (notice connected).
You’ve got the wire connected to the correct terminal from the Yamaha however cannot link a poor degree RCA wire to high level loudspeaker stimulant, really does your very own Velodyne need RCA inputs (low/line levels) ?
Making use of one RCA – RCA cable you simply connect within the Yamahas submarine pre out (the one you are utilizing right now) to one of the Velodynes low/line amount RCA stimulant
Can you upload a photo associated with straight back regarding the Velodyne or situations exact type number ?